The hard drive that had to stay

A technician installed a new solid-state drive (SSD) in a computer and moved Windows onto it to improve performance.

Everything worked correctly. Windows ran from the SSD, and all the programmes and files were available.

After the technician removed the old hard drive, the computer would no longer boot.

The technician reconnected the old drive, and Windows started normally.

What might the computer still need from the old hard drive to boot?

How to solve the cases
An old hard drive wrapped in chains and a padlock next to a new SSD

Hints

Reveal them one at a time, only when you need them.

Solution

Windows was installed on the SSD, but the files it needed to start were still on the old hard drive. Removing that drive prevented the computer from booting.

What happened?

This computer used UEFI (Unified Extensible Firmware Interface) firmware. After the migration, the boot files remained in the EFI system partition on the old hard disk drive (HDD).

The EFI System Partition (ESP) stores the boot manager files UEFI uses to start Windows.

The computer booted in three stages:

  1. The UEFI firmware accessed the EFI partition on the old HDD.
  2. It ran Windows Boot Manager from that partition.
  3. The boot manager started Windows from the new SSD.

Windows ran from the SSD, but the computer still needed the HDD to begin booting.

How could it be fixed?

The technician needed to check that the SSD had a suitable EFI partition and rebuild the boot files there.

BCDBoot, a Windows tool for setting up or repairing the boot environment, could do this.

The technician then needed to check that UEFI used the boot manager on the SSD and confirm that the computer started with the HDD disconnected.

Further reading

Have a story worth investigating?

Suggest a case

A project by Eniun

How do you solve the cases?

Each case presents a mystery that seems to defy explanation.

A moderator who knows the solution reads the mystery to the group. The group works out what happened by asking questions, discussing hypotheses and using what they know.

You can project the case on a screen so everyone can read it and refer back to it during the discussion.

The moderator can guide the discussion without giving away the answer. If the group gets stuck, each case offers three graded hints under “Hints”, which can be revealed one at a time.

Once the moderator confirms that the group has found the answer, select “Show answer” to open the solution.

You can also solve the cases on your own: read the story, try to come up with an explanation and use the hints only when you need them.